Installation Guide5 SeriesAll Refrigerator/All Freezer
9”(22.9 cm)73–3/8”(186.4 cm)82–7/8”(210.5 cm) min.anti-tip board &opening height84–1/16”(213.5 cm) max.anti-tip board &opening height35–5/8”(9
Bottom of anti-tip board is 3–7/8” (9.8 cm) below opening height.Note: Top of unit must be placed firmly under anti-tip board. 79–3/8”(201.6 cm) min.
24”(61.0 cm)1”(2.54 cm)Between Units82–3/4”(210.2 cm)min.to84–1/16”(213.5 cm)max.20–3/4”(52.7 cm)22–3/16”(56.4 cm)75–15/16”(192 .9 cm)3–19/32”(9.1 cm)
24”(61.0 cm)1”(2.54 cm)Between Units82–3/4”(210.2 cm)min.to84–1/16”(213.5 cm)max.20–3/4”(52.7 cm)22–3/16”(56.4 cm)75–15/16”(192 .9 cm)3–19/32”(9.1 cm)
24”(61.0 cm)1”(2.54 cm)Between Units82–3/4”(210.2 cm)min.to84–1/16”(213.5 cm)max.20–3/4”(52.7 cm)22–3/16”(56.4 cm)75–15/16”(192 .9 cm)3–19/32”(9.1 cm)
15Dual All Refrigerator/All Freezer* Description (2) 30” Units (1) 36” & (1) 30” Unit (2) 36” UnitsOverall width 60” (152.4 cm) 66” (167.6 cm)
24”(61.0 cm)1”(2.54 cm)Between Units82–3/4”(210.2 cm)min.to84–1/16”(213.5 cm)max.20–3/4”(52.7 cm)23–3/8”(59.4 cm)75–15/16”(192 .9 cm)3–19/32”(9.1 cm)2
1724”(61.0 cm)1”(2.54 cm)Between Units82–3/4”(210.2 cm)min.to84–1/16”(213.5 cm)max.20–3/4”(52.7 cm)23–3/8”(59.4 cm)75–15/16”(192 .9 cm)3–19/32”(9.1 cm
24”(61.0 cm)1”(2.54 cm)Between Units82–3/4”(210.2 cm)min.to84–1/16”(213.5 cm)max.20–3/4”(52.7 cm)23–3/8”(59.4 cm)75–15/16”(192 .9 cm)3–19/32”(9.1 cm)3
19Dual All Refrigerator/All Freezer w/Flush Mount Trim*Description (2) 30” Units (1) 36” & (1) 30” Unit (2) 36” UnitsOverall width 60” (152.4 cm
2Table of ContentsWarnings & Important Information_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
9”(22.9 cm)73–3/8”(186.4 cm)82–7/8”(210.5 cm) min.anti-tip board &opening height84–1/16”(213.5 cm) max.anti-tip board &opening height59–5/8”(1
79–3/8”(201.6 cm) min.to bottom of anti-tip board80–1/2”(204.6 cm) max.to bottom of anti-tip boardOne 2”x 4” mounting board per unit1–1/2” (3.8 cm) x
9”(22.9 cm)73–3/8”(186.4 cm)82–7/8”(210.5 cm) min.anti-tip board &opening height84–1/16”(213.5 cm) max.anti-tip board &opening height65–5/8”(1
79–3/8”(201.6 cm) min.to bottom ofanti-tip board80–1/2”(204.6 cm) max.to bottom ofanti-tip boardNote: If unit is installed deeper than24” (61.0 cm), t
9”(22.9 cm)73–3/8”(186.4 cm)82–7/8”(210.5 cm) min.anti-tip board &opening height84–1/16”(213.5 cm) max.anti-tip board &opening height71–5/8”(1
79–3/8”(201.6 cm) min.to bottom ofanti-tip board80–1/2”(204.6 cm) max.to bottom ofanti-tip boardNote: If unit is installed deeper than24” (61.0 cm), t
Top ViewTop View1–13/16”(4.6 cm)Space if 24” (61.0 cm)standard cabinetdepth is usedDoor24”(61.0 cm) Standard cabinet depthWall3/
Top View1–13/16”(4.6 cm)Space if 24” (61.0 cm)standard cabinetdepth is usedDoor24”(61.0 cm) Standard cabinet depthWall3/4”(1.9 cm
Top ViewTop ViewDoor24”(61.0 cm)Standard cabinet depth25”(63.5 cm)countertop depthWall3/4”(1.9 cm)Full end panel DoorWall1”(2.5 cm)space if25” (
Top ViewFlush mount cabinet doorsTop ViewOverlapping cabinet doorsDoor24”(61.0 cm)Standard cabinet depth24-3/4”(62.9 cm)Wall3/4”(1.9 cm)Full end panel
3IMPORTANT–Please Read and Follow!• Make sure that incoming voltage is the same as unit rating. An electric rating plate specifyingvoltage, frequency,
3/4”(1.9 cm)End panel5/32”(0.4 cm)3/16”(0.5 cm)Back fillerpanel22-7/16”(57.0 cm)22-7/16”(57.0 cm)22-1/4”(56.5 cm)6”(15.2 cm)Optional kickplate notchDi
3/4”(1.9 cm)End panel1”(2.5 cm)1/4”(0.6 cm)Z-Bracket21-3/4”(55.2 cm)21-3/4”(55.2 cm)24”(61.0 cm)Optional kickplate notchDimensions determined by cabin
32Area RequirementsVerify the following:• Unit can fit into residence and can bemoved around corners and throughdoorways.• Floors can support unit’s w
33Water Supply Requirements(All Freezer)Use only 1/4” (6 mm) copper tubing forwater line. Do Not install copper tubing inarea where temperatures drop
• Most of the unit’s weight is at the top.Extra care is needed when moving the unitto prevent tipping. • Do Not remove protective film until unit isin
3512Place unit in front of cutout.Pull the center grille louver up at an angle and pull out.34Using an 8” magnetic nut driver, remove the two 1/4” scr
36Remove 4 side screws and remove unit top.Loosen the 4 hinge screws. Adjust door. Retighten 4 hinge screws.Replace unit top. Replace 4 side screws.At
3793”3”3”10aPlug in power cord to verify operation. Note: Make sure power switch and showroom switchare in the “On” Position.Place unit within 3” of b
38Turn on water supply and check for leaks.Lift unit off rollers to desired height and level unit usinga 5/16” head wrench.Note: DO NOT use an electri
39312201221110˚120˚90˚Open refrigerator door so door stop and shoulder screw are accessible.Note: Shoulder screw should be in 110˚ door opening positi
24”(61.0 cm)35”(88.9 cm)75–15/16”(192.9 cm)3–19/32”(9.1 cm))36”36”(91.5 cm)(91.5 cm)36”(91.5 cm)26-1/2”(67.3 cm)9–5/32”(23.3 cm)82–3/4”(210.2 cm)min.t
40Press “ACTIVATE CONTROLS” button pad and closedoor.Note: There is a 6 minute delay before the unit starts. 26
41 Verify cabinet size. Verify electrical supply and watersupply (if applicable). Install anti-tip device(s) and verify unit issecure. Positio
42Control Panels1. Press “Activate Controls” pad.2. Verify unit is not in Sabbath Mode.If in Sabbath Mode:A. The Sabbath Mode will disable the inter
43Only authorized replacement parts may be used in performing service on the appliance. Do notrepair or replace any part of the appliance unless speci
Viking Range, LLC111 Front StreetGreenwood, Mississippi 38930 USA(662) 455-1200For product information,call 1-888-(845-4641)or visit our web site at v
530” All Refrigerator/All FreezerDescription VCFB/CVCFB VCRB/CVCRBOverall width 30” (76.2 cm)Overall height from bottom 82-3/4” (210.2 cm) min. to 84-
24”(61.0 cm)35”(88.9 cm)75–15/16”(192.9 cm)3–19/32”(9.1 cm)36”36”(91.5 cm)(91.5 cm)36”(91.5 cm)26–1/2”(67.3 cm)9–5/32”(23.3 cm)82–3/4”(210.2 cm)min.to
730” All Refrigerator/All Freezer with Flush Mount TrimDescription VCFB/CVCFB Flush Mount VCRB/CVCRB Flush MountOverall width 30” (76.2 cm)Overall he
9”(22.9 cm)73–3/8”(186.4 cm)82–7/8”(210.5 cm) min.anti-tip board &opening height84–1/16”(213.5 cm) max.anti-tip board &opening height29–5/8”(7
Bottom of anti-tip board is 3–7/8” (9.8 cm) below opening height.Note: Top of unit must be placed firmly under anti-tip board. Anti-Tip LocationFlush
Commentaires sur ces manuels