Viking E-1600-52A-EWP Manuel télécharger pdf (Page 7)

Repeat

ON ONOFF

ON OFF ON ON ONOFF OFF

OFF

0.10

sec

0.10

sec

0.10

sec

0.20 sec

0.10

sec

0.05

sec

0.025

sec

Typ.

0.025

sec

Typ.

8 Pulses

OFF

0.80 sec

OFF

0.80 sec

OFF

0.80 sec

OFF

0.80 sec

Repeat

Single

Flash:

Double

Flash:

Quad

Flash:

Flicker

Flash:

Feature # : Description:

1 Beacon/Strobe (factory default)

2 Strobe Only

3 Beacon Only

4 Strobe Brightness 1-6 (factory default = 6/Brightest setting)

5 Beacon Brightness 1-6 (factory default = 6/Brightest setting)

6 Single Flash Strobe (factory default)

7 Double Flash Strobe

8 Quad Flash Strobe

9 Flicker Flash Strobe

10 Reset to Factory Default Settings

C. Programming Features List

D. Strobe Flash Patterns

Operation

When the control module detects an incoming ring signal, it activates a set of normally open or normally closed

contacts and turns on the 12VDC output for activating the provided strobe light. With the Ring Cadence mode off

(DIP switch 2 OFF), the relay will activate and the strobe light will flash only during ringing. With the Ring Cadence

mode ON (DIP switch 2 ON), the relay will remain activated and the strobe light will remain flashing between rings.

A. Ring Indication (DIP Switch 1 ON)

When the control module detects an off-hook condition (loop current) on the brown and gray wires, it activates a

set of normally open or normally closed contacts and turns on the 12VDC output for activating the provided strobe

light. The relay contacts will remain activated and the blue strobe light will flash during the off-hook condition and

will stop flashing approximately 3 seconds after the phone/terminal device on the brown and gray wires is back

on-hook.

B. Off-Hook Indication (DIP Switch 3 ON)

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire

Viking E-1600-52A-EWP Manuel Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Viking E-1600-52A-EWP