Viking Platinum 16 Guide de l'utilisateur télécharger pdf (Page 18)

Page 18

Inserting the Bobbin

Note: Turn off the power switch while inserting the bobbin

case or anytime your hands are near the needle area.

1. Place the bobbin in the bobbin case so that the thread

pulls off clockwise when viewing the open side

(Figure 11).

2. Slide the thread through the slot (Figure 12) and

under the tension spring leaving 5-6 inches of thread

hanging loose (Figures 12 and 13).

Bobbin and Thread Tension Adjustments

Figure 11

Figure 12

3. To insert the bobbin case into the machine, grasp the

bobbin case with thumb and ﬁrst ﬁnger. Do not lift the

lever on bobbin case. Fit the bobbin case onto the hook

spindle in the machine. Rotate the case until the open

throat keys into the alignment notch in the middle of

the hook. Push the case in until it stops in place. Push

the case inward further until it clicks (see Figure 14).

Allow the thread end to hang freely.

NOTE: Pulling out the latch lever pushes the bobbin forward

in the bobbin case, aiding in removal of the bobbin. The lever

should be used only for removing the bobbin case from the

machine.

Figure 14

Figure 13

TENSION

SPRING

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 33 34

Pas de commentaire

Viking Platinum 16 Guide de l'utilisateur Page 18