Viking VWD527SS Manuel d'utilisation et d'entretien télécharger pdf (Page 9)

Cleaning and Maintenance

Any piece of equipment works better and lasts longer when maintained properly and kept clean. Cooking equipment is no

exception. Your warming drawer must be kept clean and maintained

properly. Make sure all controls are in the “OFF” position.

1. Allow warming drawer to cool completely.

2. It is important to keep the slide rails clear and free from debris. Periodic cleaning of slide rails and other adjoining parts is

necessary to assure smooth drawer operation.

3. If needed, the warming drawer pan support can be removed for cleaning. Pull the warming drawer out until fully extended.

Slide  nger along right and left side rail until you reach hand latches (located at the front of rails). Pull up on on the left side

latch and press down on the right latch at the same time and pull out the drawer pan.

Removing / Replacing the Drawer

Pull out warming drawer pan until fully

extended

Slide  nger along right and left side until you reach the hand

latches (located approximately in the center of the rail). Pull up on

on the left side latch and press down on the right latch at the same

time and pull out the drawer pan.

WARNING

To prevent burns, do not remove drawer while hot.

Be sure drawer is empty before removing.

Cabinet mounted

receiver

Drawer mounted

rail

Rail guide on

cabinet mounted

receiver

Ensure the ball bearing retainers are fully extended forward

pror to installing the drawer slides into the cabinet slide

receptacle. Failure to bring them forward and smoothly

inserted into the drawer will result in physical damage to the

drawer slide assemblies. NOTE: It is important to ensure

that the drawer mounted rail(s) are lined up correctly into the

rail guide(s) of the cabinet mounted receiver in order to avoid

misalignment that will cause slide assembly damage

WARNING

Ball bearing

assembly fully

extended forward

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Viking VWD527SS Manuel d'utilisation et d'entretien Page 9