Viking Designer DDSB548D Guide d'installation

Viking Range Corporation111 Front StreetGreenwood, Mississippi 38930 USA(662) 455-1200For product information,call 1-888-VIKING1 (845-4641)or visit th

Top View1–13/16”(4.6 cm)Space if 24” standardcabinet depth isusedDoor24”(61.0 cm)StandardCabinet DepthWall3/4”(1.9 cm)Full End Panel2–1/2”(6.4 cm) Off

Top ViewTop ViewDoor24”(61.0 cm)StandardCabinetDepth25”(63.5 cm)CountertopDepthWall3/4”(1.9 cm)Full EndPanelDoorWall1”(2.5 cm)space if25” (63.5 cm)cab

Specifications (Designer Side-By-Side)2324”(61.0 cm)41”(104.1 cm)75–15/16”(192.9 cm)3–1/2”(8.9cm)9–5/32”(23.3 cm)82–3/4”(210.2cm)min.to84–1/16”(213.5

One 2”x 4” Mounting Board1–1/2” (3.8 cm) x 3–1/2” (8.9 cm)NOTE: If unit is installed deeper than 24” (61.0 cm), then shim behind the mounting board by

One 2”x 4” Mounting Board1–1/2” (3.8 cm) x 3 1/2” (8.9 cm)NOTE: If unit is installed deeper than 24” (61.0 cm), then shim behind the mounting board by

Specifications (Designer Bottom-Mount)2924”(61.0 cm)35”(88.9 cm)52”(132.1 cm)23–1/16”(58.5 cm)3–1/2”(8.9cm)9–5/32”(23.3 cm)82–7/8”(210.5cm)min.to84–1/

One 2”x 4” Mounting Board1–1/2” (3.8 cm) x 3–1/2” (8.9 cm)NOTE: If unit is installed deeper than 24” (61.0 cm), then shim behind the mounting board by

Top ViewTop ViewDoor24”(61.0 cm)StandardCabinetDepth25”(63.5 cm)CountertopDepthWall3/4”(1.9 cm)Full EndPanelDoorWall1”(2.5 cm)space if25” (63.5 cm)cab

3/4”(1.9 cm)End panel1”(2.5 cm)1/4”(0.6 cm)Z-Bracket21-3/4”(55.2 cm)21-3/4”(55.2 cm)24”(61.0 cm)Optional kickplateNotch, dimensions determined by cabi

General InformationWater Supply RequirementsUse only 1/4” (6 mm) copper tubing forwater line. Do Not install copper tubing inarea where temperatures d

IMPORTANT–Please Read and Follow!32Table of ContentsYour safety and the safety of others isvery important.We have provided many important safetymessag

3912aPlace unit in front of cutout.(Professional) Lift center grille louver upand pull out.2b3(Designer) Pull the center grille louver upat an angle a

4193”3”3”10aPlug in power cord to verify operation.NOTE: Make sure power switch is in the “On” Position.Place unit within 3” of being flush with cabin

43312201221110˚120˚90˚Open refrigerator door so door stop and shoulderscrew are accessible.NOTE: Shoulder screw should be in 110˚ door openingposition

4544Locate water filter door. The door is located underthe Adjustable Cold Zone™ handle.Push upper left corner of door to release latchand pull door d

4746Replace top air grille.Using an 8” magnetic nut driver, replacethe two 1/4” screws.(Professional) Replace the center grille louver.(Designer) Repl

Control Panels1. Press “Activate Controls” pad.2. Verify unit is not in Sabbath Mode.If in Sabbath Mode:A. The Sabbath Mode will disable the interior

5150

IMPORTANT–Please Read and Follow!5IMPORTANT–Please Read and Follow!4WARNINGELECTRICAL SHOCKHAZARDDisconnect power or turnpower disconnect switch toOFF

Specifications (Professional Side-By-Side)724–11/16”(62.7 cm)41”(104.1 cm)75–15/16”(192.9 cm)3–19/32”(9.1 cm)42”(106.7 cm)9–5/32”(23.3 cm)82–3/4”(210.

Specifications (Professional Side-By-Side)924”(61.0 cm)41”(104.1 cm)75–15/16”(192.9 cm)3–19/32”(9.1cm)42”(106.7 cm)9–5/32”(23.3cm)82–3/4”(210.2 cm)min

Two 2”x 4” Mounting Boards3” (7.6 cm) x 3-1/2” (8.9 cm)NOTE: If unit is installed deeper than24” (61.0 cm),then shim behind the mountingboard by the d

Two 2”x 4” Mounting Boards3” (7.6 cm) x 3-1/2” (8.9 cm)NOTE: If unit is installed deeper than24” (61.0 cm), then shim behind the mountingboard by the

Specifications (Professional Bottom-Mount)1524–11/16”(62.7cm)35”(88.9 cm)52”(132.1 cm)23–1/16”(58.5 cm)3–19/32”(9.1 cm)36”(91.5 cm)9–5/32”(23.3 cm)82–

Two 2”x 4” Mounting Boards3” (7.6 cm) x 3-1/2” (8.9 cm)NOTE: If unit is installed deeper than24” (61.0 cm), then shim behind the mountingboards by the