Viking Emerald 122 Guide de l'utilisateur télécharger pdf (Page 27)

Reinforced Straight Stitch

Machine setting

1 Stitch pattern: 1

2 Stitch width: 0 or 5

3 Stitch length: stretch

4 Thread tension: 2 – 5

5 Presser foot: Utility foot A

This stitch is stronger than regular straight

stitch, due to the fact that it is a triple and

elastic stitch.

The reinforced straight stitch can be used

for heavy stretch fabrics, for crotch seams

which are subject to considerable strain

and for topstitching in heavy fabrics.

Button Sewing

Machine setting:

1 Stitch: 2

2 Stitch width: Adjust as necessary

3 Stitch length: Any

4 Thread tension: 3 – 7

5 Feed teeth: Lowered

Mark the fabric where the button is to

be located. Lower the feed teeth. Place

the material under the presser foot ankle.

Place the button on marking and lower

the presser bar so that the presser foot

ankle is between the holes of the button.

Hold the thread ends to one side. Turn

the handwheel and check to be sure that

the needle goes into the holes of the

button. Sew 5-6 stitches. Set the stitch

width dial to 0 and lock the threads with a

few stitches.

NOTE: Do not use this technique if

the button is less than 1 cm (3/8”) in

diameter.

Raise the feed teeth after button sewing.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 47 48

Pas de commentaire

Viking Emerald 122 Guide de l'utilisateur Page 27