Viking DLE-300 Manuel d'installation télécharger pdf (Page 25)

The information contained herein is proprietary to Lencore Acoustics Corp. and copyright protected. No part of this manual can be

copied, used or distributed without prior authorization from Lencore Acoustics Corp.

-21-

3. Wiring the Speakers and OPs

Power cables (16 gauge/2 conductor – Plenum Rated)

Data cables (CAT 5e or equivalent – 4 pair – Plenum Rated) – Straight Pin

Audio cables (CAT 5e or equivalent – 4 pair – Plenum Rated) – Straight Pin

Preparation

A. Check site drawing for wiring installation diagram

B. Use wiring diagram to determine approximate wiring lengths:

Approximately 25’ between speakers (Cat 5e - 4 pair)

Approximately 125’ between OPs (power and Cat 5e – 4 pair)

IMPORTANT: Double-check for long home runs and runs between floors, as these will

require much longer lengths of wire. Check wiring schematics for your project.

C. For more detail about system wiring, see Section 7 – Wire Schematics

Power Cables

Power cables are plenum-rated, 16-gauge, two conductor cable

One power supply powers as many as six OPs. When wiring a network with more than

six OPs follow directions for wiring between power zones. Regardless of OP’s an

additional power supply will be used between floors.

WARNING

NOTE: Do NOT activate power until the Power wires are

checked for proper polarity and all the OPs are wired for

power in a power zone. DO NOT SKIP THIS STEP!!! If

proper polarity is NOT maintained, then irreversible

damage to the OPs will occur.

DO NOT CONNECT OR DISCONNECT OPs WITH LIVE

WIRE as injury and shock may occur, and damage may

be caused to the sound masking equipment.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 59 60

Pas de commentaire

Viking DLE-300 Manuel d'installation Page 25